Plumbing needs to be done right! It can create more trouble and expense if it is not done properly! Not everyone is a plumber. If you are not up to the job, hire it out! If you can do-it-yourself, that is great! You will need the right tools and know how. Read this article for some handy tips and tricks!
Rigid copper is used for main water lines in many homes. You cannot bend rigid copper, so joints and tees must be soldered on. When soldering, always apply flux (also called soldering paste) to both surfaces. Flux retards oxidation when the copper is heated. Always use lead-free or nearly lead-free solder when sweating a copper joint.
You always want to solder correctly, the biggest mistake most people make when soldering is failing to get the interior of the fitting and the exterior of the pipe clean and shiny. Polish these surfaces with a fine emery clot until bright. When soldering, never heat the pipe, but instead heat the fitting. Doing so allows the solder to be drawn into the fitting by capillary action.
Before starting any plumbing project be sure to turn off the main water supply. Water damage can be one of the most expensive things to repair. To minimize damage turn the main water supply off as well as any shut off valves near where you are working. This will save a great deal of hardship later on.
Do not let your faucet leak. Did you know a leaky faucet can waste about 150 gallons of water every day? If you have a leak, never ignore it. It could be coming from the faucet or the pipes. Continually check pipes and faucets for extra moisture or small leaks.
If your toilet gets clogged, your plunger is not fixing it, and your water level inside of the toilet appears low, you can sometimes fix the problem by dumping warm water into your toilet at waist level (or maybe even a little higher). You can repeat this procedure once the water returns to a low level.
Taking preemptive action to fix a strange smelling kitchen sink can be a good way to keep your kitchen smelling great. Make sure not to throw hair or grease into your sink. Use baking soda if you have a strange smell coming from your drain. Make sure you use your garbage disposal if you have one to grind up any food and use water while doing this to prevent damage to the blades of the garbage disposal.
Got a leaky pipe? In many cases you can repair this yourself without the expense of a plumber. If a joint is leaking, tighten it with a pipe wrench. If the leak is coming from a damaged section of pipe, you can try repairing with a store-bought patching kit. One method involves applying waterproof tape to the section of pipe where there is leakage. Before applying the tape, make sure the pipe is thoroughly dry. Make sure that the tape covers two to three inches on either side of the breakage in the pipe.
Watch how your toilets are flushing. If you have to jiggle the handle or if it takes too long, you might have to repair some toilet parts. Replacing these parts early may help you to save on your water bills and will save you from more expensive repairs at a later date.
If water backs up from one sink to another, it is because the lines are connected. The part of the branch line for one device might be higher than another, but most likely there is also a blockage in the branch line connecting the two devices as well. This blockage must be cleaned.
Good management and prevention can help you save money on plumbing. One of the major repairs is clogs. Drains are frequently clogged by hair. Put a drain cover or a screen that is made to protect drains over your drain so that hair cannot get in. Cleaning a screen is is a lot easier than cleaning out your pipe.
In the winter months, if you live somewhere where temperatures fall below freezing, leave your faucets on a little bit to let a thin stream of water through. This will help prevent the pipes from freezing, which could be a major problem for you and all the pipes in your home.
It is important to know where your cut-off valve is for the water on your property. A water meter should be located on or near it. Many fixtures, such as sinks or toilets, will have their own valves to shut off the water to them. Make sure your entire family is aware of the location of these shut-off valves and how to use them in the event of an emergency.
Hopefully, you have found the tips and tricks above to be quite handy! Whether you hire out the job or do-it-yourself, take the necessary time to do it right. It can create more trouble and expense in the future, if it is not done properly!