Plumbing problems can cause quite an uproar for a homeowner that is not familiar with fixing these types of issues. Professional plumbers usually have a waiting list, and can be extremely expensive for minor repairs that could be taken care of without that much trouble. Read on to find out how to make plumbing problems easy!

Dependable Plumbing INC

To help you repair a leaky water line, you should hire a plumber. A leaky water line can be a problem because it could lead to a flood. The best way to fix this problem is to hire a licensed plumber who is trained to repair the leak.

If you have issues with the plumbing making a hammering sound when you turn it off, check your water pressure. Any time your water pressure is above 80 PSI, you will hear extra water noise. This can be easily solved by the installation of a pressure-reducing valve, which can be done by most homeowners.

Use your garbage disposal with the cold water running so that you can preserve the blades of the disposal. Using hot water makes grease more liquid and can cause problems, including clogs. Make sure to clean blades by putting in a little dish detergent and run cold water at the same time.

Check your gas water heater periodically to make sure the pilot flame is lit. The correct color for this flame should be blue. The tip of the flame should be yellow. If you find that you are only seeing a yellow flame, you may need to call a professional for safety reasons.

To keep your garbage disposal lasting for a long time, make sure you clean it on a daily basis. Prevent unsavory disposal odors through regular use of citrus peel, cherry pits and dish detergent.

Have you tried patching your pipe with the store-bought patching kits only to have that section of your plumbing continue leaking? Replacing the damaged pipe is a more permanent solution than patching. First, you must shut off the main water valve, and drain the water from the damaged section. Cut out the damaged section of the copper pipe, leaving about an inch of extra pipe on both sides of the damaged area. Remove corrosion from inside the pipes with a wire brush. Apply flux to the replacement pipe and the remaining pipe. Slide the piece of replacement pipe into place with couplings. Apply solder all around the joint, and use a propane torch to solder the replacement section into place.

Prevention will save you money in plumbing bills. The repairs that plumbers perform the most are for drains that are clogged. One major thing that causes clots is grease. It builds up over and time. You can help prevent grease build up by looking for a product on the market that will clean the grease out.

If water is backing up into multiple fixtures all over the house, it is no longer going to be effective for you to use chemicals or a small hand snake. This is evidence of a blockage in the main line, and you must contact a professional to take care of this problem for you.

Do not ignore a slow flushing toilet. This is usually a sign that something is wrong. It can also cause backups and overflows. The most common causes of a slow flushing toilet are sediment build up, tank malfunctions, or partial clogs. You should periodically check for these problems.

Believe it or not, it is not a very good idea to use a plunger if your toilet is clogged. Plungers just push whatever is stuck deeper into the drain. Instead, it is a better idea to use a closet auger. It will do a better job and is affordable.

Using a snake tool to remove blockages is very easy. Just insert the tool a few inches into the drain, and then turn the handle to change the direction of the snake head and search for blockages. Continue moving down slowly and searching until you find the cause of your blockage.

In the winter months, if you live somewhere where temperatures fall below freezing, leave your faucets on a little bit to let a thin stream of water through. This will help prevent the pipes from freezing, which could be a major problem for you and all the pipes in your home.

When having a consultation about a job with the plumber, take the opportunity to get to know them andtheir business better. Ask about their experience with the type of job that you are wanting to have done. Being comfortable with your contractor is important. They may be spending significant amounts of time in your house depending on the complexity of the job. You want to be convinced that they’re up to the task.

As you can see, plumbing problems don’t have to be so difficult. If you can solve the problem yourself, you can save time waiting for a plumber, as well as saving a whole lot of money. Try applying what you’ve learned from this article next time you have a plumbing problem!

Dependable Plumbing INC